您好,歡迎光臨中科聚峰機械有限公司網站! 主營自動攪拌車,攪拌一體車,自動上料攪拌車等各種規格的產品。

自動上料攪拌車行業持續先行者!

點擊撥打服務熱線:4008791999

您的位置:首頁 - 新聞中心 > 公司新聞 >

自動上料攪拌車安裝前后的操作說明

發布時間:2022-05-27 來源:http://www.unaxis.com.cn/ 瀏覽量:

概述:自動上料攪拌車安裝前的操作說明: Operating instructions before installation of automatic feeding mixer: 1 請注意攪拌機必須
自動上料攪拌車安裝前的操作說明:
Operating instructions before installation of automatic feeding mixer:
1.請注意攪拌機必須順時針方向運轉(由上往下看朝右轉方向)。
1. please note that the mixer must run clockwise (from top to bottom to right).
2.當您使用攪拌機時,需要適當容量的電源。如果使用了小容量的電源,便有可能會發生無法啟動的清形,請千萬注意電源容量。
2. when you use the mixer, you need a power supply of appropriate capacity. If a small capacity power supply is used, it may cause the cleaning that cannot be started. Please pay attention to the power capacity.
3.請確認您使用的頻率及電壓是否和銘牌記載的規格相同。(尤其是以發動機供電時,更須注意頻率及電壓的變動)。
3. please confirm whether the frequency and voltage you use are the same as those recorded on the nameplate. (especially when the power is supplied by the engine, pay attention to the change of frequency and voltage).
4.請在攪拌機的額定電壓變動之容許值的±10%以內使用電壓。
4. please use the voltage within ± 10% of the allowable value of the rated voltage variation of the mixer.
5.移動攪拌機時,千萬不可以拉電纜線,以免電纜線破裂,絕緣下降造成漏電。
5. when moving the mixer, do not pull the cable to avoid electric leakage caused by cable breakage and insulation decline.
6.請確實地使用接地線。
6. please use grounding wire reliably.
7.為防止觸電發生,必須加裝防止觸電之漏電斷路器。為延長攪拌機的使用壽命,建議加裝無容絲開關。
7. to prevent electric shock, a leakage circuit breaker must be installed to prevent electric shock. In order to prolong the service life of the mixer, it is recommended to install a hairless switch.
8.請勿使攪拌機埋在污泥中。
8. do not bury the mixer in the sludge.
自動上料攪拌車
自動上料攪拌車安裝期間的操作說明:
Operating instructions during installation of automatic feeding mixer:
1.安裝攪拌機的適當位置,至少須離入水面10cm以上。
1. the proper position for installing the mixer must be at least 10cm above the water surface.
2.攪拌機電纜線安裝后,須超出水面,如家長時,須在連接處以防水膠帶及絕緣膠帶妥當包扎,并適當地固定。
2. after the mixer cable is installed, it must exceed the water surface. If it is a home, it must be properly wrapped with waterproof tape and insulating tape at the connection and properly fixed.
3.攪拌機安裝時,地腳螺栓需固定牢固。
3. when installing the mixer, the foundation bolts shall be fixed firmly.
4.可加裝液位控制器(建議使用非電極式,如水銀式或鋼珠式),讓攪拌機自動操作,液位控制器之運轉及停止水位應適當調整,以避免攪拌機長期低于持續運轉水位(C、W、L)下操作。
4. a liquid level controller (non electrode type, such as mercury type or steel ball type is recommended) can be installed to allow the mixer to operate automatically. The operation and stop water level of the liquid level controller should be adjusted appropriately to avoid the mixer operating below the continuous operation water level (C, W, l) for a long time.
根據不同行業,不同工作環境、不同攪拌目的所要求的攪拌機的選型也非常之重要,選型不當容易造成攪拌機使用壽命低,故障率高等后果的產生。更多相關內容就來網站www.unaxis.com.cn咨詢了解吧!
The type selection of mixer required by different industries, working environments and mixing purposes is also very important. Improper type selection will easily lead to low service life and high failure rate of mixer. For more information, please visit www.jfhntjbc Www. 68mn!

截屏,微信識別二維碼

欧美人与动牲交zooz3d,国产精品国产一区二区三区,国产av一区二区三区日韩,免费大片黄国产在线观看