您好,歡迎光臨中科聚峰機械有限公司網站! 主營自動攪拌車,攪拌一體車,自動上料攪拌車等各種規格的產品。

自動上料攪拌車行業持續先行者!

點擊撥打服務熱線:4008791999

您的位置:首頁 - 新聞中心 > 公司新聞 >

自動攪拌車出現不工作的情況怎么找原因?

發布時間:2022-04-27 來源:http://www.unaxis.com.cn/ 瀏覽量:

概述:  自動攪拌車對于環境的適應能力挺好的,不過要知道在長期使用攪拌機之后,就容易出現突然不工作的現象,尤其是在夏天,出現這種情況的幾
  自動攪拌車對于環境的適應能力挺好的,不過要知道在長期使用攪拌機之后,就容易出現突然不工作的現象,尤其是在夏天,出現這種情況的幾率會增大。那么自動攪拌車出現不工作的情況怎么找原因?
  The ability of automatic mixer to adapt to the environment is good, but you should know that after long-term use of blender, it is easy to suddenly do not work, especially in the summer, the probability of this situation will increase. So how to find the reason why the automatic mixer does not work?
  要進行徹底的檢查,不要著急將攪拌機的電源拔掉,可以重新啟動,看一下可不可以正常運行,但是這并不代表著,如果可以正常運行就代表著沒有任何問題。即使可以正常運行,我們也需要聽一下它工作時震動的聲音,看一下是不是有很大的噪音,如果有,說明是主機出現了問題。
  To do a thorough check, don't be in a hurry to unplug the blender, restart it and see if it works, but that doesn't mean there's nothing wrong with it. Even if it works normally, we also need to listen to the sound of vibration when it works, to see if there is a lot of noise, if there is, it means that the host has a problem.
  確定的自動攪拌車油路是否暢通,柴油機供給系統沒有空氣后,可拆開油泵蓋板,板動操縱手柄,撥動油泵拉桿,看拉桿是否靈活和柱塞彈簧是否斷裂。
  After determining whether the automatic agitator oil line is smooth and the diesel engine supply system has no air, the cover plate of the oil pump can be removed, the plate dynamic control handle, and the pull rod of the oil pump can be moved to see whether the pull rod is flexible and whether the plunger spring is broken.
  在自動攪拌車拉桿靈活和柱塞彈簧沒斷的情況下,可啟動柴油機中速運轉10分鐘,還有斷火現象時,可用一只銅榔頭輕輕敲擊輸油泵大螺帽,一邊敲一邊聽柴油機聲音,如果聲音不正常,說明自動攪拌車輸油泵活塞和推桿發卡,進行修理或更換。
  In automatic mixers telescopic flexible and plunger spring isn't broken, can activate medium speed diesel engine running 10 minutes, and fire phenomenon, can use a copper hammer tapping the oil transfer pump big nut, while beating while listening to the sound of diesel engine, if the voice is not normal, automatic mixing oil transfer pump piston and push rod hairpin, for repair or replacement.
  油嘴不霧化,油泵柱塞彈簧和彈簧座斷裂,卡死不工作,或是柴油內有水。拆下油嘴總成檢查開啟壓力和霧化,如果油嘴總成正常,可讓用戶用干凈柴油裝入壺中用油路旁接法進行試驗。
  The nozzle does not atomize, the plunger spring and spring seat of the oil pump are broken, stuck and do not work, or there is water in the diesel oil. Remove the nozzle assembly to check the opening pressure and atomization. If the nozzle assembly is normal, the user can use clean diesel oil in the pot for roadside connection test.
  自動攪拌車剛剛停止作業時,發動機的冷卻液,所有零件中的油,排氣管和消聲器都處在高溫下,如果拆缷蓋子或排油或更換濾油器等都會造成燙傷或其它傷害,應等待溫度降下來后再進行保養和檢查。
  When the automatic stirring car has just stopped operation, the coolant of the engine, the oil in all parts, the exhaust pipe and the muffler are under high temperature. If the lid is removed or the oil is discharged or the oil filter is replaced, it will cause burns or other injuries. Maintenance and inspection should be carried out after the temperature drops.
  自動攪拌車出現不工作的情況怎么找原因?以上便是相關內容了,我們要懂得用正確的辦法來應對這種情況的發生,當然平常的定期養護必不可少。更多知識就來網站www.unaxis.com.cn看看吧!
  How to find the reason why the automatic mixing car does not work? The above is the relevant content, we should know how to use the right way to deal with the occurrence of this situation, of course, the regular maintenance is essential. Come to www.unaxis.com.cn for more knowledge!

截屏,微信識別二維碼

欧美人与动牲交zooz3d,国产精品国产一区二区三区,国产av一区二区三区日韩,免费大片黄国产在线观看